Installation guide

---

Step 1: Measure the wall and fasten the screws

Measure your wall and mark where you want the panels to be mounted. Use a bubble level in order to make it straight. Drive the screws through the moss and a bit into the felt, so they’re ready for being mounted onto the wall.

Step 2: Mount the panels with screws

Mount the panels by driving the fastened 30mm screws (screws not included) into the wall in the desired spot. Use 4-5 screws per panel.

Step 3: Mount the panels with glue

If you want to glue the panels to your wall instead – put glue on the felt side of the panel, and press the panel against the wall in the desired spot. Hold the panel and press it against the wall for around 10-15 seconds.

Step 4: Cutting the panels

If the panels need to be cut in size you can use a pocket knife. Cut from the felt side for an even cut.

Step 5: Add a beautiful finish with end lamellas

If you want to add a beautiful finish to your moss wall you can add end lamellas to the sides of the panel area. Cut end lamellas to the wished length with a circular saw, and make sure to cut the ends in bevel.

---

Now you are done!